Getting started with RSUni -> xBusy always High
Hello,
I am currently setting up a connection between an RS458 interface and an RS UNI module. The connection between both participants is to be realised via a 5 m long cable.
Unfortunately, I can't get the RS UNI running and send some telegrams/data packets. Immediately after starting the system, the pin xBusy = High and cannot be forced low.
What are the reasons for this pin being high?
How can the pin set low?
Greets
I am currently setting up a connection between an RS458 interface and an RS UNI module. The connection between both participants is to be realised via a 5 m long cable.
Unfortunately, I can't get the RS UNI running and send some telegrams/data packets. Immediately after starting the system, the pin xBusy = High and cannot be forced low.
What are the reasons for this pin being high?
How can the pin set low?
Greets
Comments