Contact and Coil Label Wrap Issue
I know this was fixed in a recent release(pretty sure 2024.0), but is there a workaround for this in the older versions? Any way to get the label to display both lines properly?
I know this was fixed in a recent release(pretty sure 2024.0), but is there a workaround for this in the older versions? Any way to get the label to display both lines properly?
Comments
Dear sparky66,
unfortunately it is not possible to fix it via a workaround in older versions.
The fix was done in the code for the viewer/editor and not in a modifyable section somehwere else.
Kind regards
Carsten